Installing a sump pump is one of the most effective ways of mitigating water from flooding in your basement. However, for the Zoeller pump to work properly, it needs to be installed correctly, using the right tools and techniques.
Although it might seem like a hectic process, installing a sump pump is actually quite easy to execute!
Tools and Materials Required
As long as you have the right tools, you can install a Zoeller sump pump in your basement, without having to hire a professional plumber.
Some of the tools you will need include:
- Zoeller sump pump kit
- Digging tools
- Silicon Sealant
How to Install the Sump Pump
After you have assembled all the necessary tools, it is time to install the pump. Here is a step by step guide on how to correctly install the Zoeller sump pump.
- Find an Appropriate Location
Before you set up your pump, you need to identify the best location in your basement. It is advisable to install the pump in a place where most of the water collects.
- Dig a Sump Pit
Once you have located the best spot, use a jackhammer to break through the concrete, and then dig a sump pit using your shovel. It is recommended that you dig a hole six inches deeper and ten inches wider than your sump pump in order to get enough room for piping water.
- Install the Sump Pump
When installing the sump pump in the pit, ensure that it is upright, and not slanted towards any direction.
- Cover the Pit with Gravel
Pour gravel on top of it until you are left with only two inches below ground. This will allow the pump to remain sturdy and immovable.
- Set Up the Adaptors
Glue the male adaptor to the PVC pipe, and then place it in the female adaptor. Drill a hole into the discharge pipe so that water can flow back into the pump when it is switched off.
- Install a Check Valve
Install the check valve by attaching the pump’s electrical cord to the discharge pipe, then connect the check valve to the open end of the discharge pipe.
- Finish the Piping
Once the check valve is done, connect the piping and channel the water to a nearby drainage system.
- Test the Sump Pump
Conduct a test on the sump pump to ensure that all the components are working properly.
- Cover Your Sump Pump
Firmly cover the sump pump with a lid in order to avoid minor accidents, and to protect children from it. It is advisable to cordon off the sump pump with iron bars if your children frequent your basement.
Even after you have successfully installed the Zoeller sump pump, you should regularly monitor its performance. This will enable you to identify any damaged components and promptly get them fixed.
Installing a Zoeller sump pump is the best way to protect your basement from flooding. However, with the right tools, you can conduct a DIY installation and save money.
It is as easy as that!
ALSO, YOU CAN CHECK HERE MORE ABOUT Best Wayne Sump Pump TO IMPROVE YOUR KNOWLEDGE!